SN74LVCR162245DL 供应商
-
SN74LVCR162245DL
品牌：TI 封装/批号：原厂原装/22+
SN74LVCR162245DL 属性参数
- 标准包装：25
- 类别：集成电路 (IC)
- 家庭：逻辑 - 缓冲器，驱动器，接收器，收发器
- 系列：74LVCR
- 逻辑类型：收发器，非反相
- 元件数：2
- 每个元件的位元数：8
- 输出电流高，低：12mA，12mA
- 电源电压：2.7 V ~ 3.6 V
- 工作温度：-40°C ~ 85°C
- 安装类型：表面贴装
- 封装/外壳：48-BSSOP（0.295"，7.50mm 宽）
- 供应商设备封装：48-SSOP
- 包装：管件
- 其它名称：296-8620-5
产品特性
- Member of the Texas Instruments Widebus™ Family
- Operates From 2.7 V to 3.6 V
- Inputs Accept Voltages to 5.5 V
- Max tpd of 8.5 ns at 3.3 V
- Typical VOLP (Output Ground Bounce) <0.8 V at VCC = 3.3 V, TA = 25°C
- Typical VOHV (Output VOH Undershoot) >2 V at VCC = 3.3 V, TA = 25°C
- Bus Hold on Data Inputs Eliminates the Need for External Pullup/Pulldown Resistors
- All Outputs Have Equivalent 26- Series Resistors, So No External Resistors Are Required
- Latch-Up Performance Exceeds 250 mA Per JEDEC Standard JESD-17
- ESD Protection Exceeds JESD 22 2000-V Human-Body Model (A114-A) 200-V Machine Model (A115-A)
- 2000-V Human-Body Model (A114-A)
- 200-V Machine Model (A115-A)
产品概述
This 16-bit (dual-octal) noninverting bus transceiver is designed for 2.7-V to 3.6-V VCC operation.The SN74LVCR162245 is designed forasynchronous communication between data buses. The control-function implementation minimizes external timing requirements.This device can be used as two 8-bit transceivers or one 16-bit transceiver. It allows data transmission from the A bus to the B bus or from the B bus to the A bus, depending upon the logic level at the direction-control (DIR) input. The output-enable (OE)\ input can be used to disable the device so that the buses are effectively isolated.All outputs, which are designed to sink up to 12 mA, include 26- resistors to reduce overshoot and undershoot.Active bus-hold circuitry is provided to hold unused or floating data inputs at a valid logic level. Use of pullup or pulldown resistors with the bus-hold circuitry is not recommended. The bus-hold circuitry is part of the input circuit and is not disabled by OE\ or DIR.To ensure the high-impedance state during power up or power down, OE\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
SN74LVCR162245DL