SN65LVDM31DG4 供应商
-
SN65LVDM31DG4
品牌：TI 封装/批号：原厂原装/22+ -
SN65LVDM31DG4
品牌：TI(德州仪器) 封装/批号：SOIC-16/2022+
SN65LVDM31DG4 属性参数
- 标准包装：40
- 类别：集成电路 (IC)
- 家庭：接口 - 驱动器，接收器，收发器
- 系列：-
- 类型：线路驱动器，发射器
- 驱动器/接收器数：4/0
- 规程：-
- 电源电压：3 V ~ 3.6 V
- 安装类型：表面贴装
- 封装/外壳：16-SOIC（0.154"，3.90mm 宽）
- 供应商设备封装：16-SOIC N
- 包装：管件
- 配用：296-9736-ND - EVAL MOD FOR SN65LVDM31/LVDS32B
产品特性
- Designed for Signaling Rates Up to 150 Mbps
- Low-Voltage Differential Signaling With Typical Output Voltage of 700 mV and a 100- Load
- Propagation Delay Time of 2.3 ns, Typical
- Single 3.3-V Supply Operation
- One Driver's Power Dissipation at 75 MHz, 50 mW, Typical
- High-Impedance Outputs When Disabled or With VCC < 1.5 V
- Bus-Pin ESD Protection Exceeds 12 kV
- Low-Voltage CMOS (LVCMOS) Logic Input Levels Are 5-V Tolerant
产品概述
The SN65LVDM31 incorporates four differential line drivers that implement the electrical characteristics
of low-voltage differential signaling. This product offers a low-power alternative to 5-V
PECL drivers with similar signal levels. Any of the four current-mode drivers will deliver a minimum
differential output voltage magnitude of 540 mV into a 100- load when enabled by either an
active-low or active-high enable input.
The intended application of this device and signaling technique is for both point-to-point and
multiplexed baseband data transmission over controlled impedance media of approximately 100 . The transmission media may be printed-circuit board
traces, backplanes, or cables. The ultimate rate and distance of data transfer is dependent upon the attenuation
characteristics of the media and the noise coupling to the environment.
The SN65LVDM31 is characterized for operation from -40°C to 85°C.
SN65LVDM31DG4