IC元器件

REG104GA-5/2K5

参考价格:¥20.01-¥38.43

Texas Instruments 电源管理 IC

REG104GA-5/2K5 供应商

REG104GA-5/2K5 属性参数

  • 制造商:Texas Instruments
  • 产品种类:低压降 (LDO) 调节器
  • 最大输入电压:15 V
  • 输出电压:5 V
  • 回动电压(最大值):0.5 V at 1 A
  • 输出电流:1 A
  • 输出端数量:1
  • 输出类型:Fixed
  • 最大工作温度:+ 85 C
  • 安装风格:SMD/SMT
  • 封装 / 箱体:SOT-6
  • 输入偏流(最大值):0.6 mA
  • Input Voltage MIN:+ 2.1 V
  • 最小工作温度:- 40 C
  • 封装:Reel
  • 参考电压:1.295 V
  • 工厂包装数量:2500
  • 电压调节准确度:2 %

产品特性

  • NEW DMOS TOPOLOGY: Ultra Low Dropout Voltage: 230mV typ at 1A and 3.3V Output Output Capacitor NOT Required for Stability
  • FAST TRANSIENT RESPONSE
  • VERY LOW NOISE: 33µVRMS
  • HIGH ACCURACY: ±2% max
  • HIGH EFFICIENCY: IGND = 1.7mA at IOUT = 1A Not Enabled: IGND = 0.5µA
  • 2.5V, 2.7V, 3.0V, 3.3V, 5.0V AND ADJUSTABLE OUTPUT VERSIONS
  • THERMAL PROTECTION
  • SMALL SURFACE-MOUNT PACKAGES: SOT223-5, DDPAK-5
  • APPLICATIONS PORTABLE COMMUNICATION DEVICES BATTERY-POWERED EQUIPMENT MODEMS BAR-CODE SCANNERS BACKUP POWER SUPPLIES
  • PORTABLE COMMUNICATION DEVICES
  • BATTERY-POWERED EQUIPMENT
  • MODEMS
  • BAR-CODE SCANNERS
  • BACKUP POWER SUPPLIES

产品概述

The REG104 is a family of low-noise, low-dropout linear regulators with low ground pin current. Its new DMOS topology provides significant improvement over previous designs, including low dropout voltage (only 230mV typ at full load), and better transient performance. In addition, no output capacitor is required for stability, unlike conventional low dropout regulators that are difficult to compensate and require expensive low ESR capacitors greater than 1µF.Typical ground pin current is only 1.7mA (at IOUT = 1A) and drops to 0.5µA in not enabled mode. Unlike regulators with PNP pass devices, quiescent current remains relatively constant over load variations and under dropout conditions.The REG104 has very low output noise (typically 33µVRMS for VOUT = 3.3V with CNR = 0.01µF), making it ideal for use in portable communications equipment. On-chip trimming results in high output voltage accuracy. Accuracy is maintained over temperature, line, and load variations. Key parameters are tested over the specified temperature range (–40°C to +85°C).The REG104 is well protected—internal circuitry provides a current limit which protects the load from damage. Thermal protection circuitry keeps the chip from being damaged by excessive temperature. The REG104 is available in the DDPAK-5 and the SOT223-5.