MAX211IDWR 供应商
-
MAX211IDWR
品牌：TI 封装/批号：原厂原装/22+
MAX211IDWR 属性参数
- 标准包装：1
- 类别：集成电路 (IC)
- 家庭：接口 - 驱动器，接收器，收发器
- 系列：-
- 类型：收发器
- 驱动器/接收器数：4/5
- 规程：RS232
- 电源电压：4.5 V ~ 5.5 V
- 安装类型：表面贴装
- 封装/外壳：28-SOIC（0.295"，7.50mm 宽）
- 供应商设备封装：28-SOIC
- 包装：®
- 其它名称：296-18496-6
产品特性
- RS-232 Bus-Pin ESD Protection Exceeds ±15 kV Using Human-Body Model (HBM)
- Meets or Exceeds the Requirements of TIA/EIA-232-F and ITU v.28 Standards
- Operates at 5-V VCC Supply
- Four Drivers and Five Receivers
- Operates Up To 120 kbit/s
- Low Supply Current in Shutdown Mode... 1 µA Typical
- External Capacitors... 4 × 0.1 µF
- Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II
- Applications Battery-Powered Systems, PDAs, Notebooks, Laptops, Palmtop PCs, and Hand-Held Equipment
- Battery-Powered Systems, PDAs, Notebooks, Laptops, Palmtop PCs, and Hand-Held Equipment
产品概述
The MAX211 device consists of four line drivers, five line receivers, and a dual charge-pump circuit with ±15-kV ESD protection pin to pin (serial-port connection pins, including GND). The device meets the requirements of TIA/EIA-232-F and provides the electrical interface between an asynchronous communication controller and the serial-port connector. The charge pump and four small external capacitors allow operation from a single 5-V supply. The devices operate at data signaling rates up to 120 kbit/s and a maximum of 30-V/µs driver output slew rate.The MAX211 has both shutdown (SHDN) and enable control (EN)\. In shutdown mode, the charge pumps are turned off, V+ is pulled down to VCC, V– is pulled to GND, and the transmitter outputs are disabled. This reduces supply current typically to 1 µA. EN\ is used to put the receiver outputs into the high-impedance state to allow wired-OR connection of two RS-232 ports. It has no effect on the RS-232 drivers or the charge pumps.
MAX211IDWR