74CB3Q3245RGYRG4 供应商
- 
									
74CB3Q3245RGYRG4
品牌:TI 封装/批号:原厂原装/22+ 
74CB3Q3245RGYRG4 属性参数
- 标准包装:3,000
 - 类别:集成电路 (IC)
 - 家庭:逻辑 - 信号开关,多路复用器,解码器
 - 系列:74CB
 - 类型:FET 总线开关
 - 电路:8 x 1:1
 - 独立电路:1
 - 输出电流高,低:-
 - 电压电源:单电源
 - 电源电压:2.3 V ~ 3.6 V
 - 工作温度:-40°C ~ 85°C
 - 安装类型:表面贴装
 - 封装/外壳:20-VFQFN 裸露焊盘
 - 供应商设备封装:20-VQFN
 - 包装:带卷 (TR)
 
产品特性
- High-Bandwidth Data Path (Up to 500 MHz)
 - Equivalent to IDTQS3VH384 Device
 - 5-V Tolerant I/Os with Device Powered-Up or Powered-Down
 - Low and Flat ON-State Resistance (ron) Characteristics Over Operating Range (ron = 4 Typical)
 - Rail-to-Rail Switching on Data I/O Ports 0- to 5-V Switching With 3.3-V VCC 0- to 3.3-V Switching With 2.5-V VCC
 - 0- to 5-V Switching With 3.3-V VCC
 - 0- to 3.3-V Switching With 2.5-V VCC
 - Bidirectional Data Flow, With Near-Zero Propagation Delay
 - Low Input/Output Capacitance Minimizes Loading and Signal Distortion (Cio(OFF) = 3.5 pF Typical)
 - Fast Switching Frequency (fOE\ = 20 MHz Max)
 - Data and Control Inputs Provide Undershoot Clamp Diodes
 - Low Power Consumption (ICC = 1 mA Typical)
 - VCC Operating Range From 2.3 V to 3.6 V
 - Data I/Os Support 0 to 5-V Signaling Levels (0.8-V, 1.2-V, 1.5-V, 1.8-V, 2.5-V, 3.3-V, 5-V)
 - Control Inputs Can be Driven by TTL or 5-V/3.3-V CMOS Outputs
 - Ioff Supports Partial-Power-Down Mode Operation
 - Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II
 - ESD Performance Tested Per JESD 22 2000-V Human-Body Model (A114-B, Class II) 1000-V Charged-Device Model (C101)
 - 2000-V Human-Body Model (A114-B, Class II)
 - 1000-V Charged-Device Model (C101)
 - Supports Both Digital and Analog Applications: PCI Interface, Differential Signal Interface, Memory Interleaving, Bus Isolation, Low-Distortion Signal Gating
 
产品概述
												The SN74CB3Q3245 is a high-bandwidth FET bus switch utilizing a charge pump to elevate the gate voltage
 of the pass transistor, providing a low and flat ON-state resistance (ron). The low and flat ON-state resistance
 allows for minimal propagation delay and supports rail-to-rail switching on the data input/output (I/O) ports. The
 device also features low data I/O capacitance to minimize capacitive loading and signal distortion on the data
 bus. Specifically designed to support high-bandwidth applications, the SN74CB3Q3245 provides an optimized
 interface solution ideally suited for broadband communications, networking, and data-intensive computing
 systems.The SN74CB3Q3245 is organized as an 8-bit bus switch with a single output-enable (OE\) input. When OE\ is
 low, the bus switch is ON and the A port is connected to the B port, allowing bidirectional data flow between ports.
 When OE\ is high, the bus switch is OFF and a high-impedance state exists between the A and B ports.This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry prevents damaging
 current backflow through the device when it is powered down. The device has isolation during power off.To ensure the high-impedance state during power up or power down, OE\ should be tied to VCC through a pullup
 resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.